Carlson Boretrak2 - Page 95

BT2 user manual - H-5911-9004-02-B Page | 95
13.12 Holes
Tap Holes to open the Holes window. All holes in a project are listed and can be examined and edited (see section
14.1.3).
13.13 Alignments
Tap Alignments to open the Alignments window. All alignments in a project are listed and can be examined and
edited (see section 14.1.5).
13.14 Exit
Tap Exit to exit Carlson Boretrak.
A message window opens: ‘Do you want to save changes? All unsaved edits will be lost’.
• Tap Save to save all changes in your existing project and exit Carlson Boretrak.
• Tap Discard to reject any changes in your existing project and exit Carlson Boretrak.
• Tap Cancel to cancel the new project operation and remain in your current project.