SP4012 MACHINE MAINTENANCE
28
• Check cutter wheel, pockets, and teeth
for wear. If any repair is needed, see
“Servicing Cutter Wheel” section for
further instruction.
Always clean tip of grease gun fitting and grease fitting on machine before attaching hose
to prevent dirt from being forced into machine parts.
• Grease jackshaft bearings Daily. These
bearings should be purged using grease
EVERYDAY. Purge till new grease
comes out. Use Texaco® Starplex II
grease. Always clean tip of grease gun
fitting and grease fitting on machine
before attaching hose to prevent dirt
from being forced into machine parts.
• Grease cutter wheel bearings Daily.
These bearings should be purged using
grease EVERYDAY. Purge till new
grease comes out. Use Texaco
®
Starplex II grease. Always clean tip of
grease gun fitting and grease fitting on
machine before attaching hose to
prevent dirt from being forced into
machine parts.
• Grease idler engagement linkage
Monthly. Use Texaco® Starplex II
grease.
To Next Page