Carlton SP4012 - Servicing Cutter Wheel

SP4012 SERVICING CUTTER WHEEL
56
TOOTH SHARPENING
Begin by chamfering shank back past edge of carbide. You do this because if it is
not back far enough the shank will hit the stump and not the carbide, thus causing a
lot of vibration. Once the shank is angled far enough back, then begin sharpening
carbide.
• Cut shank with a standard rock and cut carbide with a silicone carbide or
diamond rock.
CAUTION: GRINDING CARBIDE CAN BE A HEALTH HAZARD. Use
facemask to prevent breathing in harmful material while grinding.