22 EN
CLEANING THE BODY AND CONTROL PANEL
1. Disconnect the appliance from the mains supply outlet.
2. Empty internal and external drip trays.
3. Use a damped cloth or non-scratching cleaner to clean the
water stains on the appliance and panel. Dry before use.
CLEANING THE BREWER
1. Slightly press the bottom of the service door to open it.
Remove the service door.
2. Press the release knob. Remove the brewer and rinse it under
tap water. Use the brush (16).
3. Use the cleaning cloth to clean insides of the appliance
thoroughly. Dry it completely before closing the side door.
4. Insert the brewer to its original position and install the service
door back.
5. Perform manual rinsing (see “Manual rinsing”) to finish brewer
cleaning.
CAUTION!
When lights up stably, it indicates that the brewer
is missing or installed improperly. When is flashing,
it indicates that the service door is missing or installed
improperly.
To Next Page
Loading...
