ELECTRICAL WARNINGS
Only use the specified power cord. If the power cord is damaged, it must
be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Keep the power plug clean. Remove any dust or grime that accumulates
on or around the plug. Dirty plugs can cause re or electric shock.
Do not pull power cord to unplug the unit. Hold the plug firmly and pull it
from the outlet. Pulling directly on the cord can damage it, which can lead
to fire or electric shock.
Do not modify the length of the power supply cord or use an extension
cord to power the unit.
Do not share the electrical outlet with other appliances. Improper or
insufficient power supply can cause re or electrical shock.
The product must be properly grounded at the time of installation, or
electrical shock may occur.
For all electrical work, follow all local and national wiring standards,
regulations, and the Installation Manual. Connect cables tightly, and
clamp them securely to prevent external forces from damaging the
terminal. Improper electrical connections can overheat and cause fire, and
may also cause shock. All electrical connections must be made according
to the Electrical Connection Diagram located on the panels of the indoor
and outdoor units.
All wiring must be properly arranged to ensure that the control board
cover can close properly. If the control board cover is not closed properly,
it can lead to corrosion and cause the connection points on the terminal to
heat up, catch fire, or cause electrical shock.
If connecting power to fixed wiring, an all-pole disconnection device
which has at least 3mm clearances in all poles, and have a leakage current
that may exceed 10mA, the residual current device (RCD) having a rated
residual operating current not exceeding 30mA, and disconnection must
be incorporated in the fixed wiring in accordance with the wiring rules.
WA RNING
PRODUCT INSTALLATION WARNINGS
Installation must be performed by an authorized dealer or specialist.
Defective installation can cause water leak, electrical shock, or fire.
Installation must be performed according to the installation instructions.
Improper installation can cause water leakage, electrical shock, or fire.
(In North America, installation must be performed in accordance with the
requirement of NEC and CEC by authorized personnel only.)
Contact an authorized service technician for repair or maintenance of this
unit. This appliance shall be installed in accordance with national wiring
regulations.
Only use the included accessories, parts, and specified parts for
installation. Using non-standard parts can cause water leakage, electrical
shock, re, and can cause the unit to fail.
Install the unit in a rm location that can support the unit’s weight. If the
chosen location cannot support the unit’s weight, or the installation is not
done properly, the unit may drop and cause serious injury and damage.
Install drainage piping according to the instructions in this manual.
Improper drainage may cause water damage to your home and property.
For units that have an auxiliary electric heater, do not install the unit
within 3 feet (1 meter) of any combustible materials.
Do not install the unit in a location that may be exposed to combustible
gas leaks. If combustible gas accumulates around the unit, it may cause
fire.
Do not turn on the power until all work has been completed.
When moving or relocating the air conditioner, consult experienced
service technicians for disconnection and re-installation of the unit.
Follow all safety codes. Wear safety glasses, protective clothing, and work
gloves. Use quenching cloth for brazing operations. Have re extinguisher
available.
Excessive Weight Hazard - Use two or more people when moving and
installing the unit. Failure to do so can result in back or other type of
injury. Take precautions to ensure Aluminum tubes do not come in direct
contact or allow for condensate run o with a dissimilar metal. Dissimilar
metals can cause galvanic corrosion and possible premature failure.
Failure to follow this caution may result in personal injury.
Sheet metal parts may have sharp edges or burrs. Use care and wear
appropriate protective clothing and gloves when handling parts.
WA RNING
To Next Page
Loading...
