Carrier 59SC2A - Page 14

59SC2A
front pressure switch and discard. A
new tube is shipped in the loose parts bag.
Remove relief tube from relief 3 Remove tube from relief port.
port on condensate trap.
(4) Remove pressure switch tube from
Remove the screw
that secures the trap
to the collector box and
remove trap.
Loosen clamp on inlet (1 and 2 Stage Units) Remove middle and bottom
to vent elbow. plugs. DO NOT DISCARD.
Unconverted Factory Configuration as
Viewed in the Downflow Orientation
Connect the new pressure switch
tube from Loose Parts bag to
port on front pressure switch.
Route tube through inducer
stand-—offs to adjust position
of the tube.
(9) Trim excess tube.
Connect pressure switch
tube to port on collector
box.
8
Install the two plugs
previously removed
on the open ports
of the collector box.
Attach condensate trap
with screw to collector box.
Connect relief tube
to port on collector
box.
Rotate elbow to
desired position and
tighten clamp to
3
Connect relief tube to
relief port on condensate
trap.
5
2.
(1 and 2 Stage Units)
Align condensate trap
over middie and bottom
ports of collector box.
15 lb.-in.
2
Slide tube in stand-offs
to adjust length.
Downflow Trap Configuration
A11587
Fig. 9 - Downflow Trap Configuration
(Appearance may vary)
14