Carrier 59SC2A - Page 15

If alternate vent position
is required, loosen clamp
Remove plug from
collector box.
DO
NOT
DISCARD.
on
inlet
of
vent
elbow.
Remove the screw that secures
the trap to the collector box and
(1 AND 2 STAGE UNITS) remove trap.
59SC2A
Unconverted Factory Configuration
As Viewed in the Horizontal Right Orientation
NOTE: Remove knockout in
casing before re-installing the
condensate trap.
Slide relief tube in stand-offs
to adjust length.
Attach condensate
trap with screw to
collector box.
to’ Vent elbow shown in alternate
(5) orientation. Tighten clamp on
Hl inlet to vent elbow 15 |b.-in.
Install plug on
(1)
open
port
of
Align
trap
over
middie
and
collector box (1 AND 2 STAGE UNITS) right-hand port on collector box.
Horizontal Right Trap Configuration
A11573
Fig. 10 - Horizontal Right Trap Configuration
(Appearance may vary)
15