Carrier 59SC2A - Page 16

59SC2A
Remove relief tube
(4) from port on collector
box.
NOTE: Remove knockout in
casing before re-installing the
condensate trap.
If alternate vent position
is required, loosen clamp
on vent elbow inlet.
(1 AND 2 STAGE UNITS)
Remove the screw that secures the
condensate trap to the collector box
and remove trap.
Remove relief tube from
relief port on condensate
trap.
Remove front pressure
switch tube and discard.
Anew tube is shipped in
the Loose Parts bag.
Remove middle and right
plug from collector box.
DO NOT DISCARD.
Unconverted Factory Trap Configuration
As Viewed in the Horizontal Left Orientation
Rotate
elbowto
_
@Oe@
O@
desired position NG 3
and torque clamp
on inlet 15 Ib.-in. 3 °
Slide relief tube in
stand-offs to adjust
length.
{ Install two plugs previously
removed in open ports on
collector box.
4 Connect relief tube to port
on collector box.
J Connect the new pressure switch
' 7 ) tube from Loose Parts bag to port
trap with screw to ©
collector box. +
q . Oo
Align trap over middle :
and right-hand port on ©.
(3) Attach condensate
collector box.
(1 AND 2 STAGE UNITS)
on front pressure switch.
Route pressure switch tube
8 } undermeath relief tube and
connect to port on
collector box.
6 Connect relief tube to relief
port on condensate trap.
Horizontal Left Trap Configuration
Fig. 11 - Horizontal Left Configuration
(Appearance may vary)
16
At1574