Carrier 59SC2A - Page 19

INSTALL CLAMPS ON DRAIN TUBE
DRAIN TRAP /
PULL DRAIN STUB /
THROUGH CASING,
os NOTE: Trap grommet is required only for direct-vent
\ applications.
Remove knockout.
Install grommet before
OPEN
SPRING
CLAMP
relocating
condensate
INSERT FACTORY-SUPPLIED 1/2-IN. CPVC trap.
TO 3/4-IN. PVC ADAPTER OR 1/2-IN. CPVC PIPE
*CLAMP MAY BE LOCATED ON OUTSIDE OF DRAIN
TUBE
59SC2A
RIGHT SIDE DRAIN INSTALLATION
A11342A A11582
Fig. 14 - Formed Rubber Drain Grommet Fig. 16 - Horizontal Drain Trap Grommet
Attach elbow to condensate trap
Cut formed end off
condensate drain
Formed end of elbow
grommet
Connect short end
of “Z” pipe to modified
Cut line for left side condensate drain.
Do not discard parts after NA
Factory supplied 1/2-in. CPVC to
3/4-in. PVC adapter
TRAP, DRAIN ELBOW WITH DISCHARGE PIPE
f . Formed end of grommet
J Open spring clamp. Insert — Modified drain elbow connect to
1/2-in, to 3/4-in. CPVC to condensate trap and “Z” pipe
PVC adapter or 1/2-in.
CPVC pipe
4-3/8 in
mn Ginn) Be]
LEFT SIDE DRAIN ROUTED BEHIND INDUCER
NOTE: Remove Inducer Housing for easier access, if desired.
A11581 Li2FO1s
Fig. 15 - Modify Rubber Drain Elbow Fig. 17 - Drain Trap Connection and Routing
(Appearance may vary)
19