11
• If OFF is selected your system will not control temperatures,
humidity, or fan.
• If AUTO is selected, the Infinity System Control automatically
switches between heating and cooling to maintain your comfort during
transitional seasons.
NOTE: AUTO mode is intended to switch between heating and cooling
modes based on temperature demand. A gradual auto transition is the
energy-conscious default that will satisfy the majority of customers. For
Infinity Zoning systems, some customers might have significant and
simultaneous heating and cooling demands in different zones. To address
this need, a special simultaneous heating and cooling demand auto mode
could be enabled by the Installer. When the feature is enabled and
AUTO mode is selected, the simultaneous heating and cooling demand
auto mode will alternate between heating and cooling, depending on
demand, every half hour. This may result in higher energy usage but
provide the benefit of greater comfort. Your installing contractor is able
to enable this feature, if desired. (This feature is only available with
zoned systems).
• If HEAT is selected then the Infinity System Control operates only the
heating system.
• If COOL is selected then the Infinity System Control operates only
the cooling system.
• If FAN ONLY is selected, then the Infinity System Control operates
the indoor fan but heating, cooling, humidification or
dehumidification will not take place.
3.2. Set Day and Time
• To set the day and time for your home screen enter the Main Screen by
touching anywhere on the Control.
To Next Page
Loading...
