Carrier Vector 1550-11 - Check Remote Auto Light; Check Htcon1 Relay Coil

62-61753-21
7-49
Alarm
NO.
Steps
ALARM / CAUSE
CORRECTIVE ACTION
89 CHECK REMOTE AUTO LIGHT
 TRIGGER-ON: Remote Auto light current (amp) draw is higher than 0.8 Amps.
 UNIT CONTROL: Engine and standby operation: alarm only.
 RESET CONDITION: Auto Reset when Auto light current (amp) draw is normal, or alarm may be
manually reset via keypad or by turning the unit off, then back on again.
NOTE: Follow the steps below until a problem is found. Once a repair or correction has been made, the active
alarm should clear itself (refer to reset condition above). Operate the unit through the appropriate modes to see if
any active alarm occurs. Continue with the steps below as necessary.
1
Check 2-Light Bar Wiring
a. Inspect Remote 2- Light Bar con-
nector and wiring harness.
No damaged or corroded pins.
b. Inspect harness & control box
connector pins & terminals. (See
wiring schematic Section 10.)
No physical damage to harness.
No damaged or corroded pins.
2
Check 2-Light Bar
a. Check operation of 2-Light Bar
Refer to Note 2 on page 7-2
91 CHECK HTCON1 RELAY COIL
 TRIGGER-ON: Heater Contactor 1 Relay (HTCON1R) coil current is excessive
 UNIT CONTROL: Engine and standby operation: alarm only.
 RESET CONDITION: Auto Reset or alarm may be manually reset via keypad or by turning the unit
off, then back on again.
NOTE: Follow the steps below until a problem is found. Once a repair or correction has been made, the active
alarm should clear itself (refer to reset condition above). Operate the unit through the appropriate modes to see if
any active alarm occurs. Continue with the steps below as necessary.
1
Check HTCON1R
a. Inspect relay coil and terminals.
No damage to coil.
No damaged or corroded pins.
b. Check relay coil resistance.
Refer to Section 2.12. Cannot be opened (infinite
ohms), shorted (Zero Ohms) or shorted to ground.
2
Check HTCON1R Current Draw
a. Use Component Test Mode to test
actual current draw of the circuit.
(Refer to Section 5.1.2.)
Component FET or board LED (refer to Table 5-1)
must be illuminated.
View current draw in Data List.
Refer to Section 2.12 for normal current values.
3
Check HTCON1R Wiring
a. Inspect harness & control box
connector pins & terminals. (See
wiring schematic Section 10.)
No physical damage to harness.
No damaged or corroded pins.