Carrier Vector 1550-11 - 7.10 MAINTENANCE ALARMS

62-61753-21
7-85
Alarm
NO.
Steps
ALARM / CAUSE
CORRECTIVE ACTION
7.10 MAINTENANCE ALARMS
223 ENGINE MAINTENANCE DUE
 TRIGGER-ON: The Engine Maintenance Hour Meter time has expired.
 UNIT CONTROL: Alarm Only. Alarm Light will NOT be turned on.
 RESET CONDITION: Alarm may be manually reset via keypad.
1
Check Unit Maintenance Records
a. Schedule unit into service facility
for maintenance.
Must be done soon!
2
Perform Maintenance
a. Perform appropriate engine & unit
maintenance.
Follow maintenance interval recommendations in
Section 8.2.
3
Reset Engine Maintenance Hour Meter
a. Reset hour meter for the next ser-
vice interval.
Reset Functional Parameter (refer to Table 3-2).
b. If hour meter interval is not set for
your requirements, reset the Con-
figuration, refer to Table 5-2.
Follow maintenance interval recommendations in
Section 8.2.
224 STANDBY MAINTENANCE DUE
 TRIGGER-ON: The electric motor Hour Meter time has expired.
 UNIT CONTROL: Alarm Only. Alarm Light will NOT be turned on.
 RESET CONDITION: Alarm may be manually reset via keypad.
1
Check Unit Maintenance Records
a. Schedule unit into service facility
for maintenance.
Must be done soon!
2
Perform Maintenance
a. Perform appropriate engine & unit
maintenance.
Follow maintenance interval recommendations in
Section 8.2.
3
Reset Standby General Maintenance Hour Meter
a. Reset hour meter for the next ser-
vice interval.
Reset Functional Parameter (refer to Table 3-2).
b. If hour meter interval is not set for
your requirements, reset the Con-
figuration, refer to Table 5-2.
Follow maintenance interval recommendations in
Section 8.2.