62-110395-15
5.3 DOWNLOADING DATA WITH THE PC CARD
COOL DEFROST ALARM START-STOP
SETPOINT BOX TEMPERATURE
ALARM LIST
SELECT
MANUAL
DEFROST
HEAT CONTINUOUS
+36F
-20
COPYING DATA--PLEASE WAIT
2. Insert a Download Card into the PC card slot
on the front of the microprocessor. Be certain
that the instruction label is facing the “Caution”
label. Do not force card into slot.
3. The MessageCenter will show
“COPYING DATA--PLEASE WAIT”. While the
data is being copied, the green PC CARD
STATUS LED will flash.
4. When the copy is complete,
“COPY COMPLETE, REMOVE CARD X” (“X” is
the number of empty spaces remaining on the
card) will show in the MessageCenter. The PC
Card Status LED will be solid. You may then
remove the PC card. Do not remove the card
until prompted to do so.
5. When the card is removed, the MessageCenter
will return to the default message.
6. If any other messages appear, refer to Section 6.1
MessageCenter for an explanation of the error
message. If there is an error, the PC CARD FAULT
LED will be on until the card is removed.
1. Place the Micro in PC Mode (Refer to Section 5.1), or
place the RS switch in the Start/Run Position.
7. Data must be uploaded off of the Download Card
onto a computer drive before it can be viewed.
START--STOP/
CONTINUOUS
CAUTION
2
To Next Page
Loading...