2-22
62-11039
2.13 ELECTRICAL DATA
ELECTRICAL DATA
Rating: 40amps @460 VAC
Full Load Amps (FLA)
System current limit -- high speed: 26 amps
ompressor
otor
System current limit -- low speed: 22 amps
Locked Rotor Locked rotor amps: 77 at 460V
Full Load Amps (FLA) 1.5 amps @ 65 Hz
Horsepower 0.83hp (610 watts) @ 65 Hz
RPM 3832 rpm @ 65 Hz
Condenser Fan Motor
Voltage and frequency 310 to 660 VAC; 45 to 65 Hz
Bearing lubrication Factory lubricated, additional grease not required
Rotation Clockwise when viewed from shaft end
Resistance 20 to 21 ohms
Number of heaters 3(1assembly)
Rating per rod 0.81 hp (600 watts) 335 VAC/60Hz ±5% each
HTCON2 and heater
Resistance (cold) per rod 187 ohms ±5
dual discharge evaps
Type Sheath
Current (Low Speed) 4Amps
Current (High Speed) 5.1 Amps
Number of heaters 6 (2 assemblies)
Rating per rod 1.56 hp (1150 watts) 335 VAC/60Hz ±5% each
HTCON1 and heater
Resistance (cold) per rod 97.6 ohms ±5
single discharge evaps
Type Sheath
Current (Low Speed) 2.5 Amps
Current (High Speed) 3.5 Amps
Full Load Amps (FLA) 1.1 amps
Horsepower 0.66 hp (485 watts) @ 65hz
Rotations Per Minute 1850 rpm @ 65 hz
Main Evaporator Fan
Voltage and Frequency 310 to 660 VAC 45 to 65 Hz
o
or
Bearing Lubrication Factory lubricated, additional grease not required
Rotation Clockwise or Counter-Clockwise
Resistance 34.2 to 41.8 ohms
Remote Evaporator Fan
Motor
Full Load Amps (FLA) 1amp
Frequency at High Speed 60 hz
Frequency at Low Speed 45 hz
enerator
Resistance 0.738 to 0.778 ohms
Output 22 KWA @ 0.82 p.f @ 1950 rpm
Output amps 20A
Output voltage 14.8 VDC @ 77°F(25°C)
attery
arger
Input voltage 340 to 590 VAC
Frequency 43 Hz to 68 Hz
OGF Relay Trips 40 Amps
Battery Voltage 13.7 volts @ 80°F(27°C)
Standby Power
Requirements
Voltage
Current
460/3/60
23A