Carrier VECTOR 1800 MT - Page 5

iii
62--11039
TABLE OF CONTENTS (Continued)
PARAGRAPH NUMBER Page
4.5 Temperature Range Lock 1 & 2 4-9.........................................................
4.6 ProductShieldt 4-11........................................................................
4.6.1 Modes 4-11............................................................................
4.6.2 Temperature Ranges 4-12................................................................
4.7 OUTPUT OVERRIDES 4-15................................................................
4.7.1 Speed Control Solenoid (SCS) Overrides 4-15.............................................
4.7.2 Unloader Control Overrides 4-16.........................................................
4.7.3 Suction Pressure Operation 4-18........................................................
TECHNICIAN INTERFACE 5-1.....................................................................
5.1 PC MODE/DOWNLOAD PORT 5-1.........................................................
5.2 MICROPROCESSOR CONFIGURATION AND TECHNICIAN TEST MODES 5-2.................
5.2.1 Configuration Mode 5-3................................................................
5.2.2 Component Test Mode 5-12.............................................................
5.2.3 Service Mode 5-14.....................................................................
5.3 DOWNLOADING DATA WITH THE PC CARD 5-15............................................
5.4 INSTALLING NEW SOFTWARE 5-16........................................................
5.4.1 Using The Program PC Card 5-16.......................................................
5.4.2 Using MicroProgrammer 5-17...........................................................
5.4.3 Troubleshooting Software Loading Problems 5-17..........................................
5.5 SETTING PM (PREVENTATIVE MAINTENANCE) HOURMETERS 5-18.........................
5.6 ADVANCE MICROPROCESSOR REPLACEMENT & CONFIGURATION SETUP 5-19.............
5.6.1 Microprocessor Replacement 5-19.......................................................
5.6.2 Microprocessor Setup 5-20..............................................................
5.6.3 Configurations Via Keypad 5-20.........................................................
5.6.4 Functional Parameters Via Keypad 5-21..................................................
5.6.5 DataRecorder Via ReeferManager PC Program 5-21.......................................
5.6.6 Engine And Switch--on Hour Meters Via ReeferManager PC Program 5-21....................
5.6.7 Configuration/IntelliSet Card 5-22........................................................
5.6.8 Microprocessor Final Checkout 5-22.....................................................
MESSAGECENTER 6-1...........................................................................
6.1 MessageCenter Messages 6-1.............................................................
ALARM TROUBLESHOOTING 7-1.................................................................
7.1 INTRODUCTION TO ALARM TROUBLESHOOTING 7-1......................................
7.2 NOTES 7-2...............................................................................
7.3 DRIVER/OPERATOR ALARMS 7-3..........................................................
1 LOW FUEL LEVEL WARNING 7-3.........................................................
2 LOW ENGINE OIL LEVEL 7-4.............................................................
3 LOW COOLANT LEVEL 7-5...............................................................