Carrier VECTOR 1800 MT

To Next Page

To Previous Page

62-110393-35

a.Remote Control Panel Display

WAITING FOR COMMUNICATION WITH MICROPROCESSOR

COMPARTMENT TEMPERATURE DISPLAY

SETPOINT TEMPERATURE DISPLAY

COMPARTMENT MODE STATUS (HEAT, COOL OR NULL)

COMPARTMENT WAS TURNED OFF VIA REMOTE CONTROL

COMPARTMENT IN DEFROST MODE

COMPARTMENT TEMPERATURE SENSOR MALFUNCTION

TEMP.

DISPLAY

SETPOINT

DISPLAY

NOTE: TEMPERATURE IS DISPL AYED IN °FOR°C DEPEND-

ING ON CONFIGURATION OF MICROPROCESSOR

PRESET SETPOINT

b.Starting Unit with Remote Control Panel

1. Put RS in “START/RUN”

position.

2. Press The System On/Off Key.

Power Light Will Go On.

3. Press The On/Off Key To Energize

Selected Compartment.

Main Page

Table of Contents13
Table 2-1. Model Chart22
Table 2-2. Compartment Configurations22
Table 2-3. Additional Support Manuals23
Figure 2-1. Front View24
Figure 2-2. Front View25
Figure 2-3 Evaporator Section -- Grille Removed26
Figure 2-4 Control Box27
Figure 2-5. Compressor Cylinder Head Unloaded29
Figure 2-6. Compressor Cylinder Head Loaded30
Figure 2-7. Control Module34
Table 2-4. Field Effect Transistors35
Figure 2-8. Display and Keypad36
Figure 2-9. OGF Module39
Figure 2-10. PRM Phase Reversal Module39
Table 2-5. Engine Data41
Table 2-6. Compressor Data42
Table 2-7. Component Resistance & Current Draw44
Figure 2-11. Refrigerant Circuit All Compartments Cooling46
Figure 2-12. Refrigerant Circuit -- Compartment One Cooling, Compartments 2 & 3 Heating47
Figure 2-13. Refrigerant Circuit -- Compartments One and Two Cooling, Compartment 3 Heating48
Figure 2-14. Refrigerant Circuit -- Compartments One and Three Cooling, Compartment 2 Heating49
Figure 2-15. Refrigerant Circuit -- All Compartments Heating50
Table 3-1. Unit Data69
Table 3-2. Functional Parameters74
Figure 4--1 Auto Start Sequence88
Table 4-1. Glow Time89
Table 4-2 Battery Voltages89
Figure 4--2. Continuous Run Temperature Control Operating Sequence -- Frozen Range100
Figure 4--3. Start--Stop -- Temperature Control Operating Sequence -- Perishable Range100
Figure 4--4. Start--Stop -- Temperature Control Operating Sequence -- Perishable Range101
Figure 4--5. Start--Stop -- Temperature Control Operating Sequence -- Frozen Range101
Figure 4--6. Evaporator Pressure Chart104
Figure 4--7. Refrigeration System Suction Pressures Unloading (Heat and Defrost Only)105
Figure 8--1. Priming Fuel Pump257
Figure 8--2. Mechanical Fuel Pump258
Figure 8--3. Electric Fuel Pump (Optional)258
Figure 8--4. Fuel Level Sensor Wiring259
Figure 8--5. Fuel System Diagram261
Figure 8--6. Lube Oil Flow Diagram261
Figure 8--7. Speed Control Solenoid262
Figure 8--8. Engine Crankcase Breather262
Table 8-2. Blower Wheels Identification264
Figure 8--10. Evaporator Fan Bolts265
Figure 8--11. Battery Charger265
Figure 8--19 Generator Assy269
Figure 8--20 Bolt Hole Pattern for Bell Housing and Crankshaft270
Figure 8--21. Vacuum Pump Connection273
Figure 8--23 Exploded View of Valve Plate276
Figure 8--24 Suction Valve & Positioning Springs276
Figure 8--25 Compressor Oil Pump End View277
Figure 8--26 Oil Level in Sight Glass278
Table 8-3 Compressor Torque Values278
Figure 8--27 Unloader Solenoid Valve279
Figure 8--28. Solenoid Coil Replacement279
Figure 8--29 Electronic Expansion Valve280
Figure 8--30 Electronic Expansion Valve281
Figure 8--31. Thermostatic Expansion Valve Bulb and Thermocouple282
Figure 8--32. Typical Setup for Testing High Pressure Switch283
Figure 8--33. Pressure Transducer Values283
Table 8-4 Suction and Discharge Pressure Transducer Voltages283
Table 8-5. Compressor Discharge Pressure Transducer284
Table 8-6. Compressor Suction Pressure Transducer285
Figure 8--34 Suction Modulation Valve (CSMV)286
Figure 8--35 CSMV Coil (Bi--Polar Design)287
Figure 8--36 Defrost Air Switch Test Setup289
Table 8-8. Sensor Resistance (ATT, 1RAT, 2RAT, 3RAT, 1SAT, ENCT, EVOT, CST, 1DTT, 2DTT)290
Table 8-9. Sensor Resistance (CDT)291
Table 8-10. Temperature Pressure Chart293

Carrier VECTOR 1800 MT - Page 85

Table of Contents

Related product manuals