62-110393-37
e.Pre--setting Setpoints with Remote Control Panel
1. Place RS in the “START/RUN”
position and required compart-
ment switches on the unit to the
“ON” (1) position.
2. Press Carrier logo and the lock
light will be displayed.
3. Press compartment 1 UP AR-
ROW for 10 seconds. P1 will be
displayed in all compartments.
4. Set lowest setpoint required.
5. Press Carrier logo and P2 will
be displayed. Set next highest
temperature required.
6. Follow same procedure for the
next three temperatures.
7. Pressing the second compartment
UP or DOWN ARROW key for 10
seconds will allow P1 to be displayed
and the lowest setpoint for compart-
ment 2 to be set. Continue with steps
5 and 6.
8. Repeat step 7 for compartment 3.
Pre--setting Setpoints
The control panel allows the user to pre--set 5 different
temperatures for each compartment.
NOTE
Once pre--set setpoints have been chosen,
only those 5 designated setpoints can be used.
f.Removing Pre --set Setpoints With Remote Control Panel
2. Press Carrier logo and the lock
light will be displayed.
3. Press compartment 1 UP AR-
ROW for 10 seconds. P1 will be
displayed in all compartments.
4. Set temperature to lowest pre--set set-
point and OFF will be displayed
1. Place RS in the “START/RUN”
position and required compart-
ment switches on the unit to the
“ON” (1) position.
Pre--setting Setpoints
The control panel allows the user to pre--set 5 different
temperatures for each compartment.
NOTE
Once pre--set setpoints have been chosen,
only those 5 designated setpoints can be used.
To Next Page
Loading...