6 ZP3 Fire Panel User Guide
Total Loss of Power alarm
The ZP3 panel is fitted with a Total Loss of Power alarm feature. This feature is a
prewired, independent circuit that turns on the Common Fault and System Fault
LEDs and sounds a buzzer in the event of total loss of power. This condition
occurs when the mains power has been lost and the battery has been depleted
to the extent that load shedding has occurred, prior to the entire panel being shut
down. In this state, the display is shut down, the fault LEDs are on, and the panel
buzzer is sounding.
Accessories and peripherals
In addition to the ZP-loop devices, a range of accessories and peripheral devices
is available to provide all the elements of a complete system. The ZP3 panel,
when fitted with the software shown in the specification supports the following
accessories and peripherals.
Table 4: Supported accessory and peripheral models
Description
-RDU Remote display unit (mini)
-RDU Remote display unit (full-function)
-RAC Remote I/O accessory cabinet
-RL8 Addressable relay board, 8-way
-MA8 Addressable sounder driver board (monitored), 8-way
-MIP8 Addressable input board, 8-way
-OP24 Addressable transistor output board, 24-way
-SCB-D Control bus driver board
-SCB-R Control bus receiver board
-NET1 Network driver board, single
-SB232 Serial communications board, RS-232
-2-B1 Fireman’s interface panel (Swedish)
-2-R1 Fireman’s repeater panel
-NLM2 Network loop monitor
Radio loop module (receive only)
Radio loop module (transmit and receive)
-MD3 Modem kit
Later versions of software may support additional or different devices. If in doubt,
check with your local supplier.
To Next Page
Loading...