Carrier Ziton ZP3 - Point Screen Details; Point Screen: Alarm and Device Info; Point Screen: Device Location

ZP3 Fire Panel User Guide 21
• The time of the alarm, for example 06:44, is shown at the right side of the line
(optional).
Note: In the default zone display, line 3 shows the last alarm received.
Line 4: Confirms type of alarm shown
The type of alarm, for example “FIRE”, is shown above the associated common
alarm indicator and alarm view button.
Point screen
The following paragraphs describe how to how to read the LCD display when it is
switched to the Point Screen. This screen (see Figure 12 below), is manually
accessed by pressing the View Points button in order to see the device that
caused the alarm.
Figure 12: Typical point screen
HEL P
ACCEPT
MUTE
BUZZER
RESET FI RE FAULT DI SABL ED OTH ER
SI L EN CE
ALARMS
SOUND
ALARMS
MORE
VI EW
POI N TS
3698-01
Point Address
FIRE (Point) 1001 callpoint
Exit door in passage stairway
Z001 P01 Zone Message 06:37
======FIRE (01)======================
Type of Alarm
Point Message
Zone Number
Alarm Category
Being Viewed
Type of Device
Time of Alarm
Total Number of
Points in Alarm
To p Ro w
Second Row
Third Row
Bottom Row
Line 1: Alarm and device information
• The type of alarm that exists, for example “FIRE”, “FAULT”, “DISABLED”, or
“OTHER” is displayed at the beginning of the line.
• The word Point indicates that you are viewing the point screen.
• The address of the device (or point) is given, for example “1001”.
• The type of device is shown at the end of the line, for example “call point”.
Line 2: Device location
Line 2 displays the exact location of the device (point), for example “Exit door in
passage stairway”.