16 ZP3 Fire Panel User Guide
The status indicators are organized into the columns shown in Figure 8 on page
15, and the conditions shown in Table 7 below are indicated.
Table 7: Status indicator conditions
Remarks
On Indicates that the ZP3 panel has power, either from the mains or from the standby
battery.
Indicates that a sounder, remote alarm, or extinguishing system has been
activated.
Indicates that a fault condition has been detected on a device or output. A system
fault indicates that a major fault exists in the panel.
Indicates that a device or output has been deliberately disabled.
Indicates that the activation of a sounder, remote alarm, or control output has
occurred, but that the actual operation of the output is in a delayed state.
Indicates that a zone or sensor is in a prealarm condition.*
Indicates that the panel is in a test mode, which can be initiated either manually or
automatically, or that the commissioning key is ON.
If the system is set up for coincidence detection (two active detectors are required to raise an
alarm) then this LED indicates
when one of these detectors is active. A fire alarm is triggered if a
second detector confirms the condition.
To Next Page
Loading...