33 // GB
Version 1: 4x and 2x flashers
Output 1:
Output 2:
Output 3:
Output 4:
Version 2: 2x and 1x speed flashers
Output 1:
Output 2:
Output 3:
Output 4:
Version 3: Running light
Output 1:
Output 2:
Output 3:
Output 4:
Version 4: Running light – Knight Rider
Output 1:
Output 2:
Output 3:
Output 4:
In this mode, there are 4 different versions of flashers / running lights to choose from:
The speed of the light sequences can be changed in 8 steps. If the fastest speed is reached at level 8 and the level is increased again, it is switched back to the slowest level 1.
As a special feature, the Switch 4/15P. always remembers its status (on or off), the last selected version and the last set speed in this mode. These statuses are restored each time the supply voltage
is restored via the servo connector. Once it has been set and switched on accordingly, the Switch 4/15P. can also be used as a „standalone“ flasher/running light module – without an RC transmitter
and receiver.
The intermediate ranges B and C are not evaluated in this mode.
MODE 15: FLASHER, RUNNING LIGHT
Flasher /
running light on
Change version
Speed
Brief in range A: Switches flashers / running light on or off (memory)
Long in range A:
Long in range D: Change the variant of the flasher / running light
Brief in range D: Increase speed by 1 level
Function control:
To Next Page
Loading...
Need help?
General