Cascade E-Series - Page 15

215204 Rev. 1 13
ROUBLESHOOTING
T
CL0088.ill
Check for bent
pads; straighten
or replace
Re-clamp load
so bottom edge
is even with
bottom of pads
Check
hydraulics
for high
supply
pressure
Re-clamp load
squarely
between pads
IF LOWER TIER OF LOAD
IS CREASED:
CL0093.ill
TYPICAL PAD CAMBER FOR HANDLING CARTON CASE LOADS
CANNED / BOTTLED / DENSE CASE GOODS Neutral-to-Positive
SOFT CASE GOODS Neutral-to-Negative
APPLIANCE / LARGE CASE GOODS Neutral-to-Negative
UNKNOWN LOADS
Start with neutral,
look for creases
and adjust camber
as required.
Front View – Pads
Add or increase
negative camber
(Contact Cascade
Service)
4.1-4 Carton Clamp Loads (Continued)
1
2
3
4
5