30 215204 Rev. 1
ERVICE
S
5.2-5 Carton Clamp Contact Pad
Camber Adjustment
The following procedures can be performed with the arms
in place and the Clamp mounted on the truck.
1 Extend the arms to frame width. Lower the contact
pads so that they just touch the floor.
2 Measure the distance between the pads in two places:
at the bottom center (in line with the pivot pins), and
29 in. (73 cm) above the pad bottom centers as shown.
The difference between the two measurements is the
pad camber.
3 Determine the camber adjustment required.
(See Troubleshooting Section 4.1-4.)
4 Loosen the contact pad capscrews and nuts.
NOTE: It is not necessary to remove the capscrews
and nuts to insert the shims.
5 Install shims as required. Installing shims at the bottom
and middle of the pad provide
positive
camber.
Installing shims at the top and middle of the pad
provide
negative
camber.
CAUTION: Use an equal number of shims on each
contact pad. Pad camber must be the same on both
sides of the Clamp for proper load handling.
CL0095.ill
Negative
Camber
Positive
Camber
29 in. (73 mm)
Position contact
pads to frame width
1
Measure from
pad centers
3
2
CL0089.ill
Contact Pad
Pad Stabilizer
Bottom Shim
Arm
Top Shim
Middle Shim
Pad Capscrews
and Nuts
(6 per side)
CL0556.ill
FOR MAXIMUM
POSITIVE CAMBER:
FOR MINIMUM
POSITIVE CAMBER:
One Each
1/16-in. (1.6 mm)
Middle Shim
One Each
1/8-in. (3.2 mm)
Bottom Shim
Two Each
1/16-in. (1.6 mm)
Middle Shims
Two Each
1/8-in. (3.2 mm)
Bottom Shims
NOTE: For negative camber adjustment,
install thick shims at top of pad.
Front Views
5
5
4
5
To Next Page
Loading...