Cascade E-Series - Page 6

4 215204 Rev. 1
I
NSTALLATION
2.3 Installation Procedure
Follow the steps shown to install the Clamp on the truck.
Read and understand all WARNING and CAUTION
statements. If you don't understand a procedure, ask your
supervisor, or call the nearest Cascade Service Depart-
ment for assistance.
2
Unlock Quick-Change lower mounting hooks
A
Remove pin and drop hooks into unlocked position.
B Re-install pin in lower hole.
1
Prepare Attachment
A Remove banding, set Clamp upright on
pallet. Use multiple chains to stabilize
Clamp while lifting.
B Remove bolt-on lower mounting hooks
(if equipped).
Tighten Capscrews:
Class II / III Mounting – 165 ft.-lbs. (225 Nm)
cascade
®
C-675514-1
CL0097.ill
A
Pin
LH lower
Hook
NOTE: Guides can be reversed to
reduce hook-to-carriage clearance
(See lower hook installation, Step 6).
Guide
5/8-in. (16 mm)
offset on top
provides max.
clearance.
B
CL0096.ill
B
A
WARNING: Make sure overhead
hoist has a rated capacity of at least
3500 lbs. (1600 kg).
A