Cascade E-Series - Page 8

6 215204 Rev. 1
I
CL0241.ill
NSTALLATION
5
Mount Clamp on truck carriage
A
Center truck behind Clamp.
B Tilt forward and raise carriage into position.
C Engage top mounting hooks with carriage.
Make sure centering tab engages a notch
on the top carriage bar. NOTE: Centering
tab can be oriented in 4 different positions
to center the Clamp (see illustration).
D Lift Clamp 2 in. (5 cm) off pallet.
A
B
ADJUST
SD0066.ill
Tighten Capscrews:
Class II / III Mounting – 165 ft.-lbs. (225 Nm)
Lower
Carriage
Bar
6
Install and engage lower hooks
Tap tight into position.
Inspect hooks for
excessive clearance.
(Reverse guides to reduce
clearance – See Step 2.)
cascade
®
C-675514-1
SD0065.ill
3/16 in.
(5 mm)
Max.
Lower
Carriage
Bar
BOLT-ON TYPEQUICK-CHANGE TYPE
Slide hook up
to engage
bar, install
pin in upper
hole (locked.)
CL0243.ill
4
1
2
3
ITA Class II – 0.60–0.66 in. (15–17 mm)
ITA Class III – 0.72–0.78 in. (18–20 mm)
ITA Class II – 0.32–0.36 in. (8–9 mm)
ITA Class III – 0.39–0.43 in. (10–11 mm)
CL0242.ill
Truck
Carriage
Engage Tab
C
C
C
Notch
Centering Tab
Positions