5 - OPERATING INSTRUCTIONS
105
2000 Series Header
RR04F005
Connecting the Grain Header
Connect the header to the Combine according to the
following procedure.
NOTE: Make sure the stripper extensions are
installed in the correct location for the Combine
model being used. See Stripper Extension Location
in the Header Operator’s Manual for more
information.
1. Make sure the work area is clear from all
persons, tools, pets, etc. Push the Header
Control Switch and lower the feeder. Slowly
move the Combine to the header.
2. Move the Combine into the header opening until
the feeder saddle is aligned with the header
beam. Slowly lift the header off the ground. Make
sure the header beam is seated in the feeder
saddle.
A24307
RD00H048
1. HEADER BEAM
2. FEEDER SADDLE
1
1
WARNING: Stay clear of the header when latching the header to the feeder. Reach under the feeder to
engage the latches on the bottom of the feeder.
M576
!
To Next Page
Loading...
Need help?
General
