SECTION 2 - CONTROLS, INSTRUMENTS AND OPERATION
2ï118
If the baler is equipped with wheel chocks, install
them as follows:
• On a flat surface: one in front of and one behind
a wheel.
• On a slope: one chock per wheel, either in front
of or behind each wheel, depending on the
incline.
• Install the jack and take care that the latch pin is
fully engaged and secured with the hairpin.
Place the jack in parking position 251
• Remove the safety pin and slide the foot of the
jack down.
• Install the pin in the upper hole of the foot and
then rotate the crank until the weight on the
tractor is completely released.
Release the baler from the tractor.
To Next Page
Loading...