㩷
5.2 USB Connection via Windows Mobile Device Center
To establish connection via USB interface with PC runs in Windows Vista, use Windows Mobile
Device Center (“WMDC”). The DT-X8 with the factory-setting (default) does not support the
WMDC. Follow the procedure below to change the setting on the DT-X8.
Procedure
1. Close all applications running on the DT-X8.
2. Navigate to Settings o Control Panel o USB Connection.
3. Click Connect Utility tab.
Figure 5.20
4. Choose Windows Mobile Device Center radio button and then click OK button.
Figure 5.21
gue asking your final confirmation appears. Click Y
31
5. A dialo
ES button.
Figure 5.22
-X8 starts up again.
. Mount the DT-X8 on the cradle, and then follow a message appeared in the WMDC on the PC.
6. The DT
7
㩷
To Next Page
Loading...
Need help?
General
