㩷
5.4 Connection via Ethernet Cradle
This chapter describes how to establish a high speed LAN connection on the WLAN non-integrated
models with HA-K62IO Ethernet cradle.
Follow the steps below:
1. Connect the dedicated AC adapter to the Ethernet cradle as described in Chapter 4.2.
2. Connect one end of the network cable to the Ethernet cradle and the other end to the network hub.
3. Make sure the selector switch on the back of the HA-K62IO Ethernet cradle is set to the position
“LAN”.
4. Place the DT-X8 in the cradle and navigate to Start o S
ettings o Control Panel o
Network and Dial-up Connections.
5. The following screen appears. Double click the AX887721 icon. The icon will not appear unless
the terminal is placed in the cradle.
Figure 5.28
38
㩷
To Next Page
Loading...
