54
Snapshot Tutorial
14.
Half-press the shutter button.
This will cause the camera to start pre-recording images.
• The camera will not emit a shutter sound when you half-press the shutter
button while Prerecord CS is selected.
15.
When you are ready to shoot, press the shutter button the rest of the
way down.
This will record the images in the pre-record buffer and start recording new
images in real-time. Images continue to be shot as long as you keep the shutter
button depressed.
16.
Real-time shooting will stop when you release the shutter button or
after the maximum number of shots is reached.
17.
Save the CS images (page 55).
NOTE
• Note the following when selecting a High Speed CS speed (fps) setting.
– Use a higher High Speed CS speed (fps) setting when shooting a fast-moving
subject.
– Use a slower High Speed CS speed (fps) setting when shooting a slower-moving
subject.
• Note the following when selecting a High Speed CS maximum number of shots
setting.
– The greater the number of shots, the longer it takes to save them after shooting
is complete.
• Note the following when specifying a Prerecord CS shots setting.
– A setting that results in a Prerecord CS operation that takes at least 0.3 seconds
is recommended because there is a minimal lag from about 0.1 seconds to 0.3
seconds between the point you decide to shoot and the point that the shutter
button is fully depressed.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
