OTHER SETTINGS
138
5.
Press [DISP].
• You could press [SET] in place of [DISP] if you want
to configure the alarm without an image.
6.
Use [] and [] to select the scene you want
to appear at the alarm time, and then press
[SET].
7.
After all the settings are the way you want,
press [SET].
NOTE
• When an alarm time is reached while the camera is
turned off, the alarm will sound for about one minute
(or until you stop it), and then the camera will turn
on. To stop the alarm after it starts to sound, press
any button. If the camera is on the USB cradle when
an alarm sounds, you can stop it by pressing the
USB cradle [USB] button or [PHOTO] button, or any
camera button.
IMPORTANT!
• Note that the alarm does not sound if the alarm time
is reached when any one of the following conditions
exists.
— While the camera is turned on
— While a USB data communication operation is in
progress
— While a Photo Stand operation is in progress
To Next Page
Loading...
Need help?
General
