Frequently Asked Questions
Frequently Asked Questions
■ How can I perform input and display results the same way I did on
a model that does not have Natural Textbook Format?
→ Perform the following key operation:
(SETUP) (LineIO). See
"Configuring the Calculator Setup" for more information.
■ How can I change a fraction form result to decimal form?
How can I change a fraction form result produced by a division
operation to decimal form?
→ See "Toggling Calculation Results" for the procedure.
■ What is the difference between Ans memory, independent memory,
and variable memory?
→ Each of these types of memory acts like "containers" for temporary
storage of a single value.
Ans Memory:
Stores the result of the last calculation performed. Use this memory to
carry the result of one calculation on to the next.
Independent Memory:
Use this memory to totalize the results of multiple calculations.
Variables:
This memory is helpful when you need to uses the same value multiple
times in one or more calculations.
■ What is the key operation to take me from the STAT Mode or TABLE
Mode to a mode where I can perform arithmetic calculations?
→ Press
(COMP).
■ How can I return the calculator to its initial default settings?
→ Perform the following key operation:
(CLR) (Setup) (Yes).
■ When I execute a function calculation, why do I get a calculation
result that is completely different from older CASIO calculator
models?
→ With a Natural Textbook Display model, the argument of a function that
uses parentheses must be followed by a closing parenthesis. Failing to
press after the argument to close the parentheses may cause
unwanted values or expressions to be included as part of the argument.
Example: (sin 30) + 15 (Angle Unit: Deg)
81
To Next Page
Loading...
Need help?
General
Weight and Dimensions
