13-10
2. Performing Data Communication between Two
Calculators
k Connecting Two Calculators
The following procedure describes how to connect two calculators with the optionally available
SB-62 cable*.
* Included with the calculator in some areas.
u To connect two calculators
1. Check to make sure that the power of both calculators is off.
2. Connect the two calculators using the cable.
3. Perform the following steps on both calculators to specify 3PIN as the cable type.
(1) From the Main Menu, enter the Link mode.
(2) Press 4(CABLE). This displays the cable type selection screen.
(3) Press 2(3PIN).
SB-62 cable
• Models that are supported for this configuration are shown below.
fx-CG10, fx-CG20, fx-CG20 AU, fx-CG20 CN, fx-CG50, fx-CG50 AU
Older Calculator Model
fx-9860G
III, fx-9860GII SD, fx-9860GII, fx-9860GII s, fx-9860G AU PLUS, fx-9750GIII,
fx-9750GII, fx-7400GIII, fx-7400GII
To Next Page
Loading...
Need help?
General
