8-60
8. CASIO Scientific Function Calculator Special
Commands ⇔ Text Conversion Table
The table below shows the special text strings that correspond to commands when converting
between programs and text files. For details about the operations for converting between
programs and text files, see “Converting Programs and Text Files” (page 8-7).
Important!
• Converting a program that contains the types of commands described below to a text file will
cause the commands to be converted to text strings with underbar (_) characters appended
at the beginning and end, as shown in the table below.
- A command enclosed in quotation marks (" ")
- A command in a comment line, which is a line that begins with a single quotation mark (')
Note that non-command alpha-numeric characters in a program that are enclosed in quotation
marks (" ") or are in a comment line are output to the text file as-is.
Example:
In the program: In the text file (after conversion):
"
"
˝ _Theta_ ˝
"Theta"*
1
˝ Theta ˝
"Tmax"*
2
˝ _TThetamax_ ˝
"TThetamax"*
1
˝ TThetamax ˝
"or"*
3
˝ _or_ ˝
"or"*
1
˝ or ˝
*
1
Non-command alpha-numeric characters
*
2
V-Window Tmax command
*
3
Logical operator or
Converting from a text file to a program converts the special character strings back to their
corresponding commands, shown above.
• When converting a program that contains special characters input using 6(CHAR) when
editing the program on the calculator, the special characters will be converted to character
string codes as shown below.
Example:
In the program: In the text file (after conversion):
λ
#E54A
®
#E5A5
1
#E5F0
#E641
`
#E69C
⇔
#E6D6
These codes are not included in the tables on the pages 8-61 through 8-66.
To Next Page
Loading...
Need help?
General
