Casio fx-CG50 - Page 552

16-12
Cylinder Template
Input the radius, minimum height, maximum height, and center point of the cylinder.
Inputting a coefficient that matches any of the conditions below will cause an “Invalid Setting”
error.
Radius: 0 or less
Minimum and maximum height: Same value
Cone Template
Input the values below for the desired cone.
Radius of the circular base (Radius)
Z coordinate of the base (Zmin)
Z coordinate of the apex (Zmax)
X, Y coordinates of the base center point
Inputting a coefficient that matches any of the conditions below will cause an “Invalid Setting”
error.
Radius: 0 or less
Same value for Zmin and Zmax
Inputting a Function Directly
Function line input and editing operations are the same as those in the Graph mode.
After inputting a function, press 6(SET) to return to the 3D graph function list. The newly
input formula will be included in the list.
u
•
•
•
u
•
•
•
•
•
•
•
k