ε-27
Using Setup Memory
4. In response to the confirmation message that appears, press 1(Yes) to delete the
setup.
• To clear the confirmation message without deleting anything, press 6(No).
• To recall setup data
Recalling setup data stores it in the current setup memory area. After recalling setup data,
you can edit it as required. This capability comes in handy when you need to perform a setup
that is slightly different from one you have stored in memory.
1. On the sampling screen, press 4(OTHER)2(MEMORY) to display the setup memory
list.
2. Use the f and c cursor keys to highlight the name of the setup you want.
3. Press 5(LOAD).
4. In response to the confirmation message that appears, press 1(Yes) to recall the setup.
• To clear the confirmation message without recalling the setup, press 6(No).
Note
• Recalling setup data replaces any other data currently in the current setup memory area.
However, if there is setup data for a sampling mode that is different from the current mode,
that data will not be overwritten.
To Next Page
Loading...
Need help?
General
