24
EN
Ink ribbon is being fed from the tape outlet along with the tape.
Possible Causes Action Page
Tape cartridge loaded
while the ink ribbon is
slack.
Remove the tape cartridge and
check to make sure the ink ribbon is
not broken. Next, take up any slack
in the ink ribbon and then reload the
tape cartridge.
Important!
• Before loading a tape cartridge
into the Label Printer, always
make sure you take up any slack
in the ink ribbon fi rst.
• If the ink ribbon is broken, you
must change to another tape
cartridge.
8
• Tape Cutting
Cannot cut tape.
Possible Causes Action Page
Tape cutter blade is dull. Take the Label Printer to the dealer
from whom you purchased it to have
the tape cutter blade replaced.
—
Printed text is cut off by tape cut operation.
Possible Causes Action Page
Out of tape Replace the tape cartridge with a
new one.
8
• Using Labels
Label will not adhere to a surface.
Possible Causes Action Page
The backing paper is still
on the back of the tape.
Peel the backing paper from the
back of the tape to expose the
adhesive.
15
Surface is unsuitable for
affi xing a tape.
Labels do not adhere well to
surfaces that are rough, wet, oily, or
dirty.
15
To Next Page
Loading...
