Casio KL-130 User Manual

25
EN
Error Messages/Display Messages
Message Possible Causes Action
ILLEGAL
CHARACTERS!
•
You are attempting
to input and print
characters that are
not allowed for the
bar code you are
printing.
• Re-input using proper
characters. (page 19)
INITIALIZE!
•
Data in memory has
become corrupted for
some reason.
• Press any key to initialize the
Label Printer.
LONGER
THAN SET!
OK/CANCEL
•
This message
appears when the
length of the tape
that will actually be
printed is longer than
the specifi ed tape
length.
• To print, press OK.
• To cancel printing, press .
You can then decrease the
number of characters, change
to a longer tape setting, or
select auto tape length.
LOAD A TAPE
12mm OR 18mm
• You are trying to use
the Logo function
or the bar code
function while a
6mm or 9mm tape
cartridge is loaded
in the printer.
•
Turn off the printer and
replace the tape cartridge
with a 12mm or 18mm
cartridge, and specify the
tape width setting on the
printer.
LOW BATTERY!
• Battery power is
low.
• Ambient
temperature is
below 10°C (50°F).
• Replace the batteries with
new ones or use the specifi ed
AC adaptor.
• Use the printer in a location
within the operating
temperature range (10°C to
35°C; 50°F to 95°F).
NO DATA!
• You are attempting
to recall data from
memory when there
is none stored.
• Store the data in memory and
then try again.
Message Possible Causes Action
NOT ENOUGH
DIGITS!
• You are trying to
print a bar code that
does not have the
required number of
digits.
• Re-input the correct number
of digits.
NO INPUT
TEXT!
• You are attempting
a print or preview
operation when no
text is input.
• Input the text and then try
again.
ODD NUMBER
OF DIGITS!
• There is an odd
number of input
digits when printing
an ITF bar code with
NO specifi ed for the
check digit.
• There is an even
number of input
digits when printing
an ITF bar code with
YES specifi ed for
the check digit.
• Re-input with a leading zero.
(page 19)
• Re-input with a leading zero.
(page 19)
PRINT ERROR!
• The tape became
jammed during
printing.
• Turn off the printer and
remove the tape cartridge.
Next, remove the jammed
tape.
• If the steps described above
do not clear the error message,
contact your retailer or your
nearest CASIO service center.
TOO MANY
LINES!
• The number of line
breaks you input
caused the label to
exceed the maximum
number of lines for
the tape you are
using.
• Use wider tape or reduce
the number of lines. The
maximum number of lines
for each tape width is shown
below.
6mm tape...1 line
9mm tape...1 line
12mm tape...Up to 2 lines
18mm tape...Up to 3 lines

Casio KL-130 Specifications

General

Brand	Casio
Model	KL-130
Category	Electronic Keyboard
Language	English