E-10
Selecting and Playing a Tone
Use the following procedure to layer two tones, so they
sound at the same time. The tone you specify first is
called the “main tone”, while the tone you specify
second is called the “layered tone”.
NOTE
• To use a Various tone or GM tone as the main tone, you
must first assign it to the VARIOUS/GM TONES button
(page E-9).
• You can use a Various tone or GM tone assigned to the
VARIOUS/GM TONES button as either the main tone
or the layered tone. You cannot use Various/GM tones at
the same time for both the main tone and layered tone.
1.
While holding down the TONE button of the
tone that corresponds to the main tone, press
the button that corresponds to the layered
tone.
Example: While holding down the GRAND PIANO 2
button, press the STRINGS button.
NOTE
• If you press the VARIOUS/GM TONES button to assign
its tone as the layered (second) tone, the number of the
currently assigned tone will appear on the display when
you hold down the VARIOUS/GM TONES button.
• While holding down the VARIOUS/GM TONES button,
you can use the /NO and /YES buttons to scroll
through tone numbers and change the tone assignment.
2.
To unlayer the keyboard, press any one of
the TONE buttons.
NOTE
• You can adjust the balance between the main tone and
layered tone. See “Other Settings” on page E-24 for more
information.
You can assign different tones to keys on the left side
(low range) and the right side (high range) of the
keyboard.
1.
Press the TONE button of the tone you want
to select for the high range.
Example: GRAND PIANO 2
2.
Press the SPLIT button.
• This will cause the SPLIT lamp to light.
3.
Press the TONE button of the tone you want
to select for the low range.
Example: STRINGS
4.
After you are finished using the split
keyboard, press the SPLIT button again to
unsplit it.
• This will cause the SPLIT lamp to go out.
NOTE
• You can configure the keyboard so it is layered with two
tones in the high range. To do this, first perform the layer
operation (page E-10). After that, split the keyboard as
described above.
Layering Two Tones
GRAND PIANO 2
STRINGS
Splitting the Keyboard
between Two Tones
STRINGS GRAND PIANO 2
Low range High Range
Split point
PX200_e.book 10 ページ ２００６年１０月１３日 金曜日 午後１２時５分
To Next Page
Loading...
Need help?
General
