Selecting and Playing a Tone
E-11
To specify the keyboard split point
1.
While holding down the SPLIT button, press
the keyboard key where you want the left limit
of the high range (right) tone to be.
NOTE
• The split point also is the boundary between the
accompaniment keyboard range (pages E-14 to E-16) and
the melody keyboard range. You can change the location
of the split point, which also changes the sizes of the
keyboards.
• See “Other Settings” on page E-24 for information about
another method you can use to change the split point.
Reverb. . . . . Makes your notes resonate.
Chorus . . . . Adds more breadth to your notes.
To turn effects on and off
1.
Use the REVERB and CHORUS buttons to
turn the effects on and off as shown below.
• The lamps above the buttons show whether the
effects are on or off.
To change the effect type
1.
Turn on REVERB or CHORUS.
2.
While holding down the effect button
(REVERB or CHORUS), use the /NO and
/YES buttons to change the effect type as
described below.
[Reverb]
•Reverb Value
1: Room
2: Small Hall
3: Large Hall
4: Stadium
[Chorus]
•Chorus Value
1: Light Chorus
2: Medium Chorus
3: Deep Chorus
4: Flanger (Whooshing effect)
NOTE
• While the keyboard is layered, the chorus on/off setting
affects the layered tone only. While the keyboard is split,
the chorus on/off setting affects the low range tone only.
Using Effects
High Range
High range leftmost key
Low range
Flashing
Off
Off
Lit
On
PX200_02_e.fm 11 ページ ２００６年１１月１日 水曜日 午前１１時３５分
To Next Page
Loading...
