E-4
General Guide
Normally when you press a button, it will change the
setting or perform the operation marked above the
button. Note that there also are secondary parameters
(settings) marked below some buttons that you can
select using the TEMPO/SETTING button.
• For details about the parameters you can configure
using the TEMPO/SETTING button, see
“Secondary Parameter Reference” on page E-26.
To select a secondary button parameter
1.
Press the TEMPO/SETTING button.
• This will cause the lamp below the TEMPO/
SETTING button to flash.
•The GRAND PIANO 1/TEMPO button’s lamp also
will flash.
Example:
2.
Press the button that corresponds to the
parameter you want to select.
• This will cause the button’s lamp to flash.
Example: TRANSPOSE button
• If you want to adjust the tempo, you can skip this
step because the GRAND PIANO 1/TEMPO button’s
lamp will flash already.
3.
Use the /NO and /YES buttons to
change the setting of the selected parameter.
4.
After you are finished, press the TEMPO/
SETTING button again.
• This will cause the TEMPO/SETTING lamp and the
lamp of the selected parameter button to go out.
Use the /NO and /YES buttons to change a
displayed setting.
z
zz
z Holding down either button changes the value at
high speed.
Example: See “Selecting a Various tone, GM tone, and
Drum set” on page E-9.
NOTE
• Pressing the /NO and /YES buttons at the same
time will return the displayed setting to its default.
Using the TEMPO/SETTING
Button
/NO Button and /YES
Button
PX200_02_e.fm 4 ページ ２００６年１１月１日 水曜日 午前１１時２０分
To Next Page
Loading...
