24
9.
When everything is the way you want, click [OK].
z This displays the dialog box shown below.
10.
In the “Login Code” box, enter the four-digit number shown in the upper left
corner of the LAN connection standby screen that is being projected.
11.
When everything is the way you want, click [OK].
z While the projector is connected to a computer over a wireless LAN, a Network Connection
window like the one shown below will be displayed on the computer screen. The computer
screen image (main screen) will be projected.
z For details about Network Connection window operations, see “Using Network Connection”
(page 39).
12.
To terminate the wireless LAN connection and discontinue computer screen
projection, click the close button ( ) in the upper right corner of the Network
Connection window.
z This closes the Network Connection window and returns the projected image to the LAN
connection standby screen.
Note
z After you perform the above operation, Network Connection will remember the passphrase
used for the last connection. Because of this, you will not need to input the passphrase again
if you re-connect the same computer to the projector (as long as the SSID has not been
changed).
z In the case of a wireless LAN connection using a user SSID, settings can be configured to
eliminate the need for login code input. For information about how to configure settings, see
“To configure Control Panel page network settings” (page 59).
To Next Page
Loading...
Need help?
General
