38
To establish a wired LAN connection between the projector and
a computer via a router
Note
z The procedure below assumes that a DHCP server is running on the network to which the
router belongs, and that there is a LAN connection between the computer and router.
Projector Operation
1.
Use a LAN cable to connect the projector to the router to which the computer is
connected via the LAN
2.
On the projector, select “Auto” for “IP Settings”.
(1) Perform the following steps to display the IP Settings dialog box: [MENU] key 3
“Network Settings” 3 “Projector Wired LAN Settings”.
(2) Press the [
W
] key to select “Auto” for “IP Settings”.
(3) Press the [ESC] key to return to “Network Settings”.
(4) Select “Update Network Settings” and then press the [ENTER] key.
(5) In response to the network setting update dialog box that appears, press the [S] key to select
“Yes” and then press the [ENTER] key.
Computer Operation
3.
Perform the operation from step 6 under “To use a LAN cable to connect a
computer directly to the projector” (page 36).
To Next Page
Loading...
Need help?
General
