18
12.
To terminate the wireless LAN connection and discontinue computer screen
projection, click the close button ( ) in the upper right corner of the Network
Connection window.
z This closes the Network Connection window and returns the projected image to the LAN
connection standby screen.
Note
z After you perform the above operation, Network Connection will remember the passphrase
used for the last connection. Because of this, you will not need to input the passphrase again
if you re-connect the same computer to the projector (as long as the SSID has not been
changed).
z In the case of a wireless LAN connection using a generic SSID, settings can be configured to
eliminate the need for login code input. For information about how to configure settings, see
“To configure Control Panel page network settings” (page 59).
Using a User SSID to Establish a Wireless LAN Connection
You can create a user SSID and use it to establish a wireless LAN connection when you want to
accomplish any one of the following: connection using a specific security system, make a connection
more secure, or connect without configuring security settings (without a passphrase or log in code).
Important!
z To create a user SSID, you will need to first establish a LAN connection between the projector
and computer using one of the other connection methods.
z The projector can have only one user SSID assigned to it at a time. Each time you perform the
procedure under “To create a user SSID” the current user SSID (if there is one) is overwritten
by the new one.
Wireless LAN connection
To Next Page
Loading...
Need help?
General
