49
Preparing the Computer for Wireless LAN Connection
with the Data Projector
Before attempting the operations in this section, be sure to prepare the computer by
following the steps below.
If you are using the YW-2 wireless adapter
1
On your computer, install “Wireless Connection” from the CD-ROM that comes
bundled with the Data Projector.
z For more information, see “Installing Data Projector Software” (page 11).
2
Connect the YW-2 wireless adapter to your computer’s USB port.
If you are using another wireless LAN adapter (including a computer’s built-
in wireless LAN)
1
Make sure that the wireless LAN of the computer (either a built-in wireless LAN
or add-on wireless LAN) conforms to the IEEE 802.11b standard.
2
On your computer, install “Wireless Connection” from the CD-ROM that comes
bundled with the Data Projector.
z For more information, see “Installing Data Projector Software” (page 11).
To Next Page
Loading...
