52
This section explains the basic procedures for configuring settings for a wireless LAN
connection between the Data Projector and a computer.
z This section includes the basics for establishing a wireless LAN connection between the
Data Projector and a single computer, or between the Data Projector and multiple
computers. For details about increasing security and settings required for connection to a
wireless LAN access point, see “Advanced Wireless LAN Connection Settings” (page 65).
z For details about projection operations after establishing a connection, see “Using Wireless
LAN for Projection” (page 91).
Important!
z The procedure below assumes that the Data Projector’s plug-and-play feature is turned
on (which is the initial default setting). If you have turned off plug-and-play, turn it
back on before performing the procedure below. For more details about the plug-and-
play setting, see “Setup Menu Contents” in the User’s Guide.
z The operations described here assume that the CASIO YW-2 wireless LAN adapter is
connected to the computer. In the case of a computer equipped with another
manufacturer’s wireless LAN adapter or a built-in wireless LAN adapter, configure
settings in accordance with the user documentation that comes with the adapter you
are using.
Wireless LAN Connection Basics
To Next Page
Loading...
