Casio XJ-V10X - Adjusting the Volume Level (VOLUME); To Adjust the Volume Level; To Mute the Audio

20
Use the procedure below to adjust the volume level of the projector’s speaker output, and output from
the AUDIO OUT terminal. If your projector does not have a built-in speaker, only AUDIO OUT terminal
output is affected.
To adjust the volume level
1. Press the [VOLUME +] or [VOLUME –] key.
 This causes the “Volume” screen to appear on the projected image.
2. Press the [VOLUME +] key to increase the volume, or the [VOLUME –] key to
lower the volume.
3. After the setting is the way you want, press the [ESC] key.
To mute the audio
1. Press the [VOLUME +] or [VOLUME –] key to display the “Volume” screen.
2. Press the [ENTER] key.
 This stops output from the speaker.
3. To restore the audio, press the [VOLUME +] or [VOLUME –] key.
Adjusting the Volume Level (VOLUME)