Casio XJ-V10X User Manual

66
You can connect a CASIO graphing calculator to the Data Projector using a USB cable and project the
calculator’s screen image with the Data Projector. USB connection of the following CASIO graphing
calculators is supported.
 ClassPad II (fx-CP400)
 ClassPad 330 PLUS
 fx-CG series
 fx-9860G series
 fx-9860GII series
 fx-9750GII
 GRAPH 95/85/85 SD/75/75+/35+
To project the screen image of a graphing calculator
1. While the projector is turned on, connect the USB cable that comes with the
graphing calculator to the projector’s USB-A port and the graphing calculator’s
USB port.
2. On the projector, press the [INPUT] key. This will display the “Input” dialog box.
3. Use the [] and [] keys to select “CASIO USB Tool” and then press the
[ENTER] key.
4. On the graphing calculator, perform the operation required for projection.
 For details about this operation, refer to the use documentation that comes with your
calculator.
Important!
 If the calculator does not operate properly after you connect it to the Data Projector, try
disconnecting the USB cable from the calculator and then reconnecting it. If this does not
correct the problem, disconnect the USB cable from both the Data Projector and the
calculator. Turn the Data Projector off and then back on again, and then re-connect the
calculator.
Projecting the Screen Image of a Graphing Calculator

Casio XJ-V10X Specifications

General

Number of colors	1.073 billion colors
Native aspect ratio	4:3
Projection distance	1.95 - 2.87 m
Projection technology	DLP
Contrast ratio (typical)	20000:1
Screen size compatibility	30 - 300 \
Projection distance (tele)	3.33 - 4.85 m
Projector native resolution	XGA (1024x768)
Keystone correction, vertical	+ 30/ ± 30 °
Focus	Manual
Offset	50 %
Digital zoom	2 x
Optical zoom	1.5 x
Zoom capability	Yes
Focal length range	2.31 - 2.73 mm
DVI port	No
Audio (L/R) in	0
Serial interface type	RS-232C
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Maximum digital resolution	1920 x 1080 pixels
Operating temperature (T-T)	5 - 35 °C
Placement	Desktop, Ceiling
Product type	Standard throw projector
Product color	White
Power source	-
Power consumption (standby)	180 W
Service life of light source	10000 h
Service life of light source (economic mode)	6000 h
Analog signal format system	NTSC, PAL, PAL 60, PAL M, PAL N, SECAM

Weight and Dimensions

Width	299 mm
Height	97 mm
Weight	3500 g