32
The operations described below can be password protected on the projector. You can have only one
password assigned to the projector at any time, and the same password is used for operations.
Projector startup protection
The projector can be configured so a dialog box prompting input of the password is displayed
whenever the projector is turned on. In this case, further operation of the projector is not possible
unless the correct password is input. This protects against unauthorized use of the projector.
Using projector internal storage (network models only)
Attempting to access the projector internal storage function (page 37) from the Setup Menu causes
a password input dialog box to appear. This protects against inadvertent and unauthorized deletion
or replacement of files in projector internal memory.
Use the “Power On Password” and “Internal Storage Password” settings to turn password protection
for the above operations on or off individually.
Note the following precautions whenever you use the password feature.
The password feature protects against unauthorized use of the projector. Note that it is not an
anti-theft measure.
You will need to enter the initial factory default password the first time you use the projector after
turning on the password feature. Change the initial factory default password to a different one of
your choice as soon as possible after turning on the password feature.
Remember that password operations are always performed using the remote controller, so you
should take care not to lose or misplace the remote controller.
Also note that you will not be able to input the password if the remote controller batteries are dead.
Replace the remote control batteries as soon as possible after it starts to go low.
If you forget your password...
If you forget the password, you will need to bring the following two items to your CASIO distributor to
have the password cleared. Note that you will be charged to have the password cleared.
Note that your CASIO distributor will not be able to clear the password of your projector unless you
bring both of the items listed above.
Also, keep the projector’s warranty in a safe place.
Important!
Having your password cleared using the procedure described above will return all of the
settings of your projector, except for the Light Time, to their initial factory defaults.
Keep a written record of your password!
You will not be able to use the projector if you forget its password. We strongly suggest that you keep
a written or other type of record of the password so you can look it up when necessary.
Password Protection
Using the Password Feature
1. Personal identification (original or copy of your driver’s license, employee I.D., etc.)
2. Projector unit
To Next Page
Loading...
Need help?
General
Weight and Dimensions
