Lower the car by turning the jack handle anti-
clockwise then remove the jack from under the car.
Finally fully tighten the wheel nuts in a diagonal
sequence.
WARNING!
Always check the tyre pressures before
driving off or as soon afterwards as possible.
Whenever refitting the wheel nuts it is
imperative that they are tightened to the
correct torque. Check wheel nut torque as
soon as possible.
WARNING!
Always observe the following precautions!
Choose a safe place to stop, away from the
main thoroughfare, and ensure your
passenger gets out of the car and waits in a
safe area, away from other traffic.
Switch on the hazard warning lights to alert
other road users. Apply the handbrake and
engage first gear.
Ensure the jack is positioned on firm, level
ground. Do not position the jack on metal
gratings or manhole covers, or use additional
material between the base of the jack and the
ground.
If jacking on a slope, place chocks at the front
and rear of the wheel diagonally opposite the
one to be removed.
Care must be taken to avoid accidental
contact with any underbody parts, especially
the hot exhaust system components, likely to
cause personal injury during the raising or
lowering of the car.
WARNING!
NEVER jack the car with passengers inside!
NEVER work beneath the car with the jack as
the only means of support. The jack is
designed for wheel changing only!
To Next Page
Loading...
